Aircraft support · MSFS 2024 · Free

iniBuilds A350 in FlightFabric: voice commands, cockpit controls and live data

Call out a switch and watch it move, tap the same controls on a phone or tablet beside you, and see the cockpit state read back from the aircraft. This page lists everything FlightFabric 0.10.2 can do with the iniBuilds A350, taken from the app’s own catalogue.

Applies to FlightFabric 0.10.2 public alpha · Supported aircraft · Generated from the app’s aircraft catalogue on

Development preview of the FlightFabric Aircraft page for the iniBuilds A350, showing its cockpit-system sections, presets and controls with sample data
The Aircraft page for the iniBuilds A350 · Development preview · Sample data

Aircraft covered

Load any of these in MSFS 2024 and FlightFabric switches to its cockpit layout and control set by itself. There is nothing to configure in the app.

  • iniBuilds Airbus A350-900
  • iniBuilds Airbus A350-1000

Vendor: iniBuilds. Other A350 products from other developers are not covered by this page.

Its Aircraft page describes the integration as “Live cockpit controls and aircraft status.”

What you need

  • FlightFabric 0.10.2 on the Windows PC that runs Microsoft Flight Simulator 2024, with one of the aircraft installed. MSFS and the aircraft are separate products; FlightFabric is free and needs no account.
  • Voice control is optional and runs offline in the desktop app; the voice-control guide covers microphone and push-to-talk setup in five steps.

Try saying

Hold push-to-talk, say one of these, and release. Numbers are spoken as digits, so 270 is “two seven zero”. Each phrase below is accepted by FlightFabric 0.10.2 for the iniBuilds A350.

  • “Set speed two five zero”

    Selected speed: 250 kt

  • “Set heading two seven zero”

    Selected heading: 270 deg

  • “Start apu”

    APU master ON, then request START. Requires aircraft electrical power.

  • “Set lights for takeoff”

    Landing ON · nose TAKEOFF · strobe ON · navigation NAV 1

  • “Strobe lights on”

    Strobe lights: on

  • “Seat belts on”

    Seat belts: on

Every command

The full list, grouped by cockpit system. Every control here is also available from the Aircraft page and its control library, so you can tap it on a tablet instead of saying it. Setting a target such as a heading does not engage the autopilot; the aircraft’s current mode decides how it uses the target.

Flight guidance

Flight guidance · 8 controls
ControlSayValue
Selected speed“set speed valueor 1 other phrasing100–399 kt · step 1
Selected heading“set heading valueor 1 other phrasing0–359 deg · step 1
Selected altitude“set altitude valueor 3 other phrasings0–49,000 ft · step 100
Selected vertical speed“set vertical speed valueor 1 other phrasing-6,000–6,000 ft/min · step 100
Flight director“flight director valueor 1 other phrasingOn / off
Metric altitude“metric altitude valueor 1 other phrasingOn / off
Captain vertical view“captain vertical view valueor 1 other phrasingOn / off
First officer vertical view“first officer vertical view valueor 1 other phrasingOn / off

Flight controls

Flight controls · 5 controls
ControlSayValue
Landing gear“gear valueor 1 other phrasingup · down
Flaps one detent“flaps value one”or 1 other phrasingincrease · decrease
Parking brake“parking brake valueor 1 other phrasingSet / release
Ground spoilers“ground spoilers valueor 6 other phrasingsArm / disarm
Spoilers“spoilers valueor 7 other phrasingsretracted · half · full

Exterior lights

Exterior lights · 8 controls
ControlSayValue
Strobe lights“strobe lights valueor 7 other phrasingsoff · auto · on
Nav lights“nav lights valueor 7 other phrasingsOn / off
Beacon lights“beacon lights valueor 7 other phrasingsOn / off
Landing lights“landing lights valueor 9 other phrasingsOn / off
Nose light“nose light valueor 1 other phrasingoff · taxi · takeoff
Taxi lightsUses the shared nose-light selector: TAXI or OFF.“taxi lights valueor 9 other phrasingsOn / off
Wing lights“wing lights valueor 1 other phrasingOn / off
Logo light mode“logo light mode valueor 1 other phrasingoff · auto · on

Aircraft systems

Aircraft systems · 6 controls
ControlSayValue
APU master“apu master valueor 1 other phrasingOn / off
Ram air“ram air valueor 1 other phrasingOn / off
Wing anti ice“wing anti ice valueor 1 other phrasingoff · on
Probe heat“probe heat valueor 3 other phrasingsauto · on
Cross bleed“cross bleed valueor 3 other phrasingsclosed · auto · open
Pack flow“pack flow valueor 1 other phrasingmanual · low · normal · high

Cabin signs

Cabin signs · 4 controls
ControlSayValue
Seat belts“seat belts valueor 5 other phrasingsoff · auto · on
No smoking signs“no smoking valueor 3 other phrasingsoff · auto · on
Emergency lights“emergency lights valueor 3 other phrasingsoff · arm · on
No mobile signs“no mobile signs valueor 1 other phrasingoff · auto · on

Navigation

Navigation · 4 controls
ControlSayValue
Captain ND range“captain range valueor 2 other phrasings10 · 20 · 40 · 80 · 160 · 320 · 640
Captain LS“captain ls valueor 3 other phrasingsOn / off
First officer ND range“first officer range valueor 2 other phrasings10 · 20 · 40 · 80 · 160 · 320 · 640
First officer LS“first officer ls valueor 3 other phrasingsOn / off

Presets

A preset works through several switches in order and reports each step, the way a pilot monitoring runs a flow. It stops, rather than retrying, when the aircraft does not confirm a step.

Presets

Presets · 5 presets
ControlSayValue
Start APUAPU master ON, then request START. Requires aircraft electrical power.“start apu”or 7 other phrasingsOne action
Takeoff lightsLanding ON · nose TAKEOFF · strobe ON · navigation NAV 1“set lights for takeoff”or 7 other phrasingsOne action
After-takeoff lightsLanding OFF · nose OFF“set lights after takeoff”or 10 other phrasingsOne action
Lights for landingLanding ON · nose TAKEOFF · strobe ON · navigation NAV 1“set lights for landing”or 5 other phrasingsOne action
After-landing lightsStrobe OFF · landing OFF · nose TAXI“set lights after landing”or 5 other phrasingsOne action

More cockpit controls

Individual switches in the system sections of the Aircraft page, with the positions each one can be set to. The control library search finds them too.

Exterior lights 1
  • NAV NAV 2 One action

Live cockpit data

The Aircraft page shows these 54 values as the aircraft reports them, next to the controls that change them. What you see is the switch position in the cockpit, not what the app last asked for.

Flight guidance 10
  • Speed value
  • Heading deg
  • Altitude ft
  • Vertical speed fpm
  • Flight director
  • Ls captain
  • Ls first officer
  • Vertical view captain
  • Vertical view first officer
  • Metric altitude
Exterior lights 7
  • Strobe mode
  • Beacon
  • NAV mode
  • Logo mode
  • Wing
  • Landing
  • Nose mode
Aircraft systems 22
  • Ignition mode
  • Gravity gear cover
  • Gravity gear handle mode
  • APU master
  • APU start
  • Air flow mode
  • Cross bleed mode
  • Ram air
  • Wing anti ice
  • Probe window heat mode
  • Cabin pressure altitude mode
  • Cabin pressure vertical speed mode
  • Ditching
  • Crew supply
  • Emergency electrical generator
  • Ground control
  • Electrical side isolation
  • Electrical load management
  • Passenger systems
  • Galley
  • Bus tie
  • Evacuation command
Cabin signs 4
  • Seat belts mode
  • No smoking mode
  • No mobile mode
  • Emergency exit mode
Navigation 2
  • Captain range
  • First officer range
Controls 9
  • Flaps index
  • Flap angle deg
  • Speedbrake percent
  • Spoilers armed
  • Gear handle down
  • Gear nose pct
  • Gear left pct
  • Gear right pct
  • Parking brake

Verification status

All 85 aircraft-specific controls on this page are mapped from the aircraft’s documented cockpit variables and events. The project has not yet confirmed them one by one in a live simulator session, so the app lists each of them as awaiting verification. That is a statement about the project’s own testing, not a known fault: wherever the aircraft exposes the switch state, the app reads it back before reporting success.

Every control is guarded the same way: FlightFabric sends it once, waits for the aircraft to report the new switch position, and shows a failure instead of retrying. A few momentary controls are confirmed only by the simulator accepting the command. If a control does not respond on your installation, please report it on GitHub with the aircraft version so it can be fixed.