Aircraft support · MSFS 2024 · Free

ATR 72-600 in FlightFabric: live cockpit data, monitoring only

FlightFabric follows your ATR 72-600 flight and reads 34 live cockpit values from it, covering exterior lights, aircraft systems, controls, fgcp. It does not have a control set for this aircraft yet. This page lists exactly what FlightFabric 0.10.2 does with it, taken from the app’s own catalogue.

Applies to FlightFabric 0.10.2 public alpha · Monitoring only · Generated from the app’s aircraft catalogue on

Development preview of the FlightFabric Aircraft page for the ATR 72-600, showing its live cockpit values with sample data
The Aircraft page for the ATR 72-600 · Development preview · Sample data

Aircraft covered

Load this aircraft in MSFS 2024 and FlightFabric switches to its live-data layout by itself. There is nothing to configure in the app.

  • Microsoft / S&H Software ATR 72-600

Vendor: Microsoft / S&H Software. Other ATR 72-600 products from other developers are not covered by this page.

How the app labels it: Monitoring only

Its Aircraft page describes the integration as “Expert Series passenger-variant monitoring page for MSFS 2020 and MSFS 2024.”

What you need

  • FlightFabric 0.10.2 on the Windows PC that runs Microsoft Flight Simulator 2024, with the aircraft installed. MSFS and the aircraft are separate products; FlightFabric is free and needs no account.
  • Voice control is optional and runs offline in the desktop app; the voice-control guide covers microphone and push-to-talk setup in five steps.

Standard controls

These standard simulator controls are available for this aircraft through FlightFabric’s generic control set. They are not aircraft-specific and depend on how the aircraft responds to standard simulator events.

Flight controls

Flight controls · 2 controls
ControlSayValue
Landing gearStandard simulator control.“gear valueor 1 other phrasingup · down
Flaps one detentStandard simulator control.“flaps value one”or 1 other phrasingincrease · decrease

Live cockpit data

The Aircraft page shows these 34 values as the aircraft reports them, next to the controls that change them. What you see is the switch position in the cockpit, not what the app last asked for.

Exterior lights 7
  • Strobe
  • Beacon
  • NAV
  • Logo
  • Wing
  • Landing
  • Taxi
Aircraft systems 9
  • Engine 1 running
  • Engine 2 running
  • Fuel total pct
  • Fuel total weight lbs
  • Gross weight lbs
  • Cabin altitude ft
  • Cabin vertical speed fpm
  • Cabin delta pressure psi
  • Outside air temperature C
Controls 8
  • Flaps percent
  • Flaps index
  • Flap angle deg
  • Gear handle down
  • Gear nose pct
  • Gear left pct
  • Gear right pct
  • Parking brake
Fgcp 10
  • Speed kts
  • Heading deg
  • Altitude ft
  • Vertical speed fpm
  • AP master
  • Flight director
  • Heading select
  • Altitude mode
  • Vertical speed mode
  • Approach

Verification status

FlightFabric 0.10.2 has no aircraft-specific controls for the ATR 72-600, so there is nothing to verify beyond the standard controls above. The live values are read straight from the aircraft.